Hydac EDS 1700 Bedienungsanleitung PDF herunterladen (Seite 32)

8.2. ALTERING THE HARDWARE PROGRAMMING ENABLE

l Disconnect the unit from the supply voltage.

l Remove the 4 screws from the unit front panel (Illustration 1).

l Lift front panel off carefully and put to one side.

l Push slide switch on the lower board to the required position (Illustration 2):

"OFF": programming disabled.

l Replace front panel on the unit and screw into position, ensuring that the

front panel seal is in the correct position.

off

Illustration 1

Illustration 2

9. Altering the mounting position

l Disconnect the unit from the supply voltage.

l Remove the 4 screws from the front plate of the unit (Illustration 1).

l Carefully lift off the front panel and turn through 180°.

l Replace the front panel on the unit and screw into position, ensuring that the

front panel seal is in the correct position (Illustration 2).

Illustration 1 Illustration 2

pressure connection

programming

possible

disable

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 55 56

Keine Kommentare

Hydac EDS 1700 Bedienungsanleitung Seite 32