Hydac CMWIN Bedienungsanleitung PDF herunterladen (Seite 12)

CMWIN ENGLISH Page 12

Edition 06/2007

3 Using CMWIN

Note:

For all options, selections can only be made using the mouse.

3.1 Sensor information

Sensor information gives more precise information on the connected sensor.

• Click on the "SMART sensor" dialogue box.

• "SMART sensor" opens in a new window.

• Establish a link with the SMART sensor (see 2.6 Establishing a link with the

SMART sensor).

• Click on "Sensor information" on the left of the window.

• On the right side of the window, information appears on the SMART sensor

connected.

3.2 Viewing actual measured values of the SMART sensors in CMWIN

• To view actual measured values of the SMART sensor:

 Click on the “SMART sensors” dialogue box.

 “SMART sensor” opens in a new window.

 Establish a link with the SMART sensor (see 2.6 Establishing a link with the

SMART sensor).

 Click on "Sensor values" on the left of the window.

 In the window on the right hand side, a table appears with sensor values.

"Channel"

= designation of measurement channel

"Measured value"

= actual measured value

"Unit of measurement"

= unit of the particular measured value

Plus, if supported by sensor:

"Min"

= lowest measured value

"Max"

= peak measured value

 The width of the colums can be altered as required.

 To reset the min/max values, click on "Reset Min/Max values" under the viewing

area of the sensor values.

3.3 Retrieving a Measurement Curve

There are three ways of doing this:

You can import a measurement curve from your connected device into CMWIN, open a

saved file, or retrieve a file that is already open.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Keine Kommentare

Hydac CMWIN Bedienungsanleitung Seite 12